Lithium Ion Jump Starter and USB Power Source
OWNERS MANUAL
PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE. This manual will explain how to use the jump starter
safely and effectively. Please read and follow these instructions and precautions carefully.
1.
IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS.
WARNING: RISK OF EXPLOSIVE GASES.
WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL OPERATION.
IT IS IMPORTANT THAT YOU FOLLOW THESE INSTRUCTIONS EACH TIME YOU USE THE UNIT.
To reduce the risk of battery explosion, follow these instructions and those published by the battery manufacturer and the manufacturer of any
equipment you intend to use in the vicinity of a battery. Review cautionary markings on these products and on the engine.
WARNING! RISK OF ELECTRIC SHOCK OR FIRE.
Keep out of reach of children.
1.1
1.2
Do not disassemble the jump starter. Take it to a qualified service professional if service or repair is required. Incorrect assembly may result in fire or electrical shock.
Do not use the jump starter to jump a vehicle while charging the internal battery.
1.3
Do not recharge the jump starter with a damaged USB cable.
1.4
The jump starter gets hot during charging and must have proper ventilation.
1.5
1.6
Do not set the jump starter on flammable materials, such as carpeting, upholstery, paper, cardboard, etc.
1.7
Place the jump starter as far away from the battery being jumped as the cables will permit.
Do not expose the jump starter to rain or snow.
1.8
Never attempt to jump start a frozen battery.
1.9
1.10
Never place the jump starter directly above battery being jumped.
1.11
To prevent arcing, never allow the clamps to touch together or to contact the same piece of metal.
Use of an attachment not recommended or sold by the jump starter manufacturer may result in damage to the unit or personal injury.
1.12
Never operate the jump starter if it is damaged.
1.13
1.14
If someone else uses the jump starter, ensure they are well informed on how to use it safely, and have read and understood the operating instructions.
1.15
The jump starter is NOT designed to be installed as a replacement for a vehicle battery.
Use ONLY on vehicles, boats and garden tractors powered with a 12V DC battery system.
1.16
If the engine fails to start after the recommended number of attempts, disconnect the unit and look for other problems that may need to be corrected.
1.17
1.18
Use the jump starter for jump starting lead-acid batteries only. Do not use for dry cell batteries that are commonly used with home appliances.
2.
PERSONAL SAFETY PRECAUTIONS
2.1
Wear complete eye protection and protective clothing when working near lead-acid batteries. Always have someone nearby for help.
2.2
Have plenty of fresh water, soap and baking soda nearby for use, in case battery acid contacts your eyes, skin, or clothing. Wash immediately with soap and water and
seek medical attention.
If battery acid comes in contact with eyes, flush eyes immediately for a minimum 10 minutes and get medical attention.
2.3
2.4
Neutralize any acid spills thoroughly with baking soda before attempting to clean up.
2.5
Remove all personal metal items from your body, such as rings, bracelets, necklaces and watches. A battery can produce a short circuit current high enough to weld a ring
to metal, causing a severe burn.
Never smoke or allow a spark or flame in the vicinity of the battery or engine.
2.6
This product contains a lithium ion battery. In case of fire, you may use water, a foam extinguisher, Halon, CO
2.7
or soda (sodium carbonate) to extinguish the fire. Once the fire is extinguished, douse the product with water, an aqueous-based extinguishing agent, or other nonalcoholic
liquids to cool the product and prevent the battery from re-igniting. NEVER attempt to pick up or move a hot, smoking, or burning product, as you may be injured.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
2.8
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
, ABC dry chemical, powdered graphite, copper powder
2
• 3 •
FOR MODELS
SL1435
SL1439
SL1519