Electrical Diagram; Electrical Components - Haverland RC-A 2013 Manuel D'installation Et Utilisation

MAINTAINANCE
This thermal transmitter does not need any special maintenance.
Dust it with a dry and soft cloth ONLY WHEN THE TRANSMITTER IS DISCONNECTED AND IS
COLD.
NEVER USE DISOLVENTS OR ABRASIVE PRODUCTS.
We recommend to clean the surface of the transmitter at the beginning of the heating season
(ALWAYS BEFORE SWITCHING IT ON).
At the end of the heating season, it recommended to switch the transmitter off turning the output switch
selector in position 0.
Besides this, once the heating season is over, to unplug the transmitter from the socket.
POSSIBLE INCIDENTS
• THE TRANSMITTER DOES NOT HEAT UP. Please check that the transmitter is not covered or the
air entrances are not obstructed.
• THE TRANSMITTER DOES NOT HEAT UP ENOUGH. Please check that temperature chosen with
the room temperature selector is the desired one. If the selector knob is placed at maximum position
and the appliance is not stilll heating enough, it is possible that room needs a higher heating powder.

ELECTRICAL DIAGRAM

Marsan Industrial SA reserves the right to make any modification without previous warning.
m00r@A2013
Emissión:

ELECTRICAL COMPONENTS

B CONNECTIONS DIAGRAM
C SWITCH
TE ELECTRONIC THERMOSTAT
TS SAFETY THERMOSTAT
P LIGHT
RC RESISTANCE
Where you see this symbol on any of our electrical products or packaging, it indicates
that the relevant electrical product should not be disposed of as general household
waste in Europe. To ensure the correct waste treatment of the product, please
dispose of it in accordance with any applicable local laws or requirements for disposal
of electrical equipment. In so doing, you will help to conserve natural resources and
improve standards of environmental protection in treatment and disposal of electrical
waste.
19