Haverland RC-A 2013 Manuel D'installation Et Utilisation page 18

FIG. Nº. 7
WALL
TRANSMITTER
2
FLOOR
WALL
3
1
-
TRANSMITTER
FIG. Nº. 10
2
SCREWS
SCREWS
FIG. Nº. 9
You have just installed the HAVERLAND Thermal Transmitter. We
hope it satisfies your heating needs.
18
Take the two 6 x 40 mm screws and
-
screw each one of them lightly on
both supports (Point 1 Fig. 8).
Then take the appliance in such way
-
that the controls panel is on the right
side. Incline the appliance with the
upper part towards you.
- Place the transmitter on the lower
side of the wall separators (Point 2
Fig. 9).
Move the transmitter carefully towards the
-
left or right till it is centralized and fixed on
the two canals which are on its back.
Place the transmitter vertically and once it
-
is parallel to the wall, let it fall gently till the
upper separators get into both canals
(Point 3, Fig. 10).
To have the transmitter perfectly fixed to
-
the wall, screw completely the 6 x 40 mm
screws in the upper part of the separators
(Point 1, Fig. 8).
Make sure that the transmitter is perfectly
-
fixed to the wall to avoid future risks.
Then connect the plug to a nearby power
-
supply (socket).
FIG. Nº. 8