Simu T8 S Mode D'emploi page 12

3
Installation
The square shaped motor head allows the mounting in four different positions:
1. Limit setting screws in front, vertical manual override (for ring or invisible box output) and power supply cable at
rear.
2. Limit setting screws at rear, vertical manual override and power supply cable in front (same as 1).
3. Limit setting screws underside, horizontal manual override (for 90° box joint) and power supply cable above.
4. Limit setting screws above, horizontal manual override and power supply cable underside (same as 3)
1
Installation "between walls"
4 screws M10x20 - 8.8
4 washers
4 nuts HM10 - 08
Tightening torque : 40 N.m
Mounting on plates
4/8
2 3 4
safety brakes
directly on wall or on
plate (95 N.m and 147
N.m safety brakes)
90°
fitted