Moulinex BCB3 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When the plug is a moulded type and this is cut
off from the appliance, the connected wires
are a shock hazard. Do not under any
circumstances connect a cut off plug into the
electrical socket outlet. The cut off plug must
be disposed of in a safe manner that prevents
any form of connection.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the instruc-
tions in paragraph "Fitting a plug". With alterna-
tive plugs a 15 amp fuse must be fitted either in
the plug or adaptor or at the main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW
BLUE
BROWN
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter 'E' or by the
earth symbol or coloured green or green and
yellow. The wire which is coloured BLUE must
be connected to the terminal which is marked
with the letter 'N' or coloured black. The wire
which is coloured BROWN must be connected
to the terminal which is marked with the letter
'L' or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the requirements
of the EEC Directive (89/336/EEC).
Any connection error will nullify the
guarantee.
- This appliance is intended solely for
domestic and indoor use.
- Unplug the appliance as soon as you have
finished using it and when you clean it.
- Do not remove the plug from the socket by
pulling on the cord.
- Do not put hot water in the reservoir.
- Do not use the appliance if it is not working
properly or if it has been damaged. Any in-
tervention apart from cleaning and normal
maintenance by the customer must be
carried out by an approved Moulinex ser-
vice centre (see list in the service booklet).
: EARTH
: NEUTRAL
: LIVE
- Do not place the appliance, the power cord
or the plug in water or in any other liquid.
- Do not allow the power cord to hang down
within reach of children.
- The power cord must never be close to or
come into contact with the hot parts of your
appliance, close to any source of heat or a
sharp edge.
- Do not use the jug on a flame or an electric
hot plate (all models).
- If the power cord or the plug are damaged,
do not use the appliance. To avoid any risk
these must be replaced by an approved
Moulinex service centre (see list in the ser-
vice booklet).
- For your own safety, use only the Moulinex
accessories and spare parts which are
suitable for your appliance.
- Always close the lid of the filter-holder (F)
when using the coffee maker.
- Do not pour water into the appliance while it
is still hot.
- Remember to replace the lid on the jug to
ensure the drip-stop device functions, and
to avoid overflow of the filter-holder.
- All appliances undergo strict quality controls.
Practical use tests are conducted with
appliances selected at random, which
explains any signs of use.
Using your appliance for
the first time
- Operate the coffee maker for the first time
without ground coffee, with a full tank of
water.
- Fill the tank (A), which is graduated in small
1
and large cups, with cold water up the
desired level.
- Pour your ground coffee in a No. 4 filter paper
2
placed in the removable filter-holder (E).
- Close the lid of the filter-holder (F).
- Place the jug (D) on the hotplate (C).
3
- Start the appliance using the switch (J): the
4
indicator light will come on.
Notes:
- This coffee maker is fitted with a drip-stop
device, allowing you to serve coffee before
the water has finished running through. Re-
place the jug quickly to avoid any overflow.
- The coffee maker automatically switches to
keep-warm mode at the end of the cycle.
5
- You can adjust the length of the cord by
storing it under the appliance.
9

Publicité

Table des Matières
loading

Table des Matières