GE JCK1000 Installation page 33

Installation Instructions
Cutout for 30"
A
Ovens only
Cutout Width
(28 1/2") Min.
(28 5/8") Max.
Allow 1.75 cm
(11/16")
for overlap
of oven over
side edges of
cutout
Opening
between
inside walls
must be at
least 72.4 cm
(28 1/2") wide
58.42 cm
(23")
Allow 2.5 cm (1") for
overlap of oven top
Allow a minimum
and 3.2 cm (1
of 58.42 cm (23")
bottom of cutout
for clearance to
adjacent corners,
drawers, walls, etc.
when door is open
Cabinet
Width
76.2 cm (30")
Side-by-Side Installations
Install two ovens in separate cutouts.
Center Line Center Line
34.5" (87.6 cm)
30" models
Cutout – Cutout –
observe all observe all
dimensions and dimensions and
requirements. requirements.
6" (15.24 cm) Min.
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
of the oven. For single ovens, the runners and
braces must support 68 kg (150 lbs.).
NOTE: If marks, blemishes or the cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening are covered.
For JCT3000, JCT5000, PCT7050 models only.
72.4 cm
72.7 cm
Cutout
Height
69.2 cm
(27 1/4") Min.
69.4 cm
(27 5/16") Max.
Recommended
cutout location
")
1
4
82.6 cm (32 1/2")
Single Built-In
(76.2 cm)
Cabinet Width
Recommended
Junction box
recommended to
Cutout Location
be in right side
from Floor
adjacent cabinet
Cutout Depth
Cutout Width
Cutout Height
Suitable
Bracing
to Support
Runners
These ovens are not approved
for stackable installation.
5
76.2 cm (30")
82.6 cm (32 1/2")
59.7 cm
(23 1/2") Min.
72.4 cm
(28 1/2") Min.
72.7 cm
(28 5/8") Max.
69.2 cm
(27 1/4") Min.
69.4 cm
(27 5/16") Max.
NOTE: If the cabinet does not have
a front frame and the sides are less
than 1.9 cm (3/4") thick, shim both
sides equally to establish the
cutout width.
C L
54.9 cm
(21 5/8")
Over Centerline
of Cabinet
5 cm x 10 cm
(2" x 4") or
equivalent
runners level
with bottom
of cutout