BELINEA 10 Manuel page 15

Carefully lift the monitor out of the packaging and make
sure that all components are included (see fig. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
➧
Make sure that your computer and the LCD monitor
are disconnected from the power supply.
Connect one end of the VGA cable to the VGA
connector on your monitor (
end to your computer.
Figure 2. Connecting the monitor to the PC
➧
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
end to the Line-Out connector of the computer.
First start your PC and then turn on your Belinea
monitor using the power switch (
‚
indicator ( in fig. 4) should light up green.
Adjust the image to meet your requirements (see the
following sections ”Basic Setup” and ”Image settings
using the OSD menu”).
Downloaded from ManualMonitor.com Manuals
All manuals and user guides at all-guides.com

in fig. 2) and the other
Signal cable
„
in fig. 3) and the other

in fig. 4). The status
Figure 1. Monitor with swivel base
➧

Connect the power cable (
power socket at the designated location (
Connect one end of the power supply cable (
3) with the power supply and plug it into an electrical
outlet.
Figure 3. Connecting power supply and optional components
If there is no image displayed on the monitor, consult
the section “Troubleshooting”.
Operating Instructions -
Power cord
Power
adapter
Audio cable
VGA cable
in fig. 3) to the monitor’s
ƒ
in fig. 3).
‚
in fig.