Rega SYSTEM ONE Mode D'emploi page 5

LOUDSPEAKER ASSEMBLY
Included with your KYTEs are two rear feet (21)
and four Pozi No. 2 screws. These are required
to install the rear foot on each speaker (you will
need a PZ2/Pozi No. 2 screwdriver). Place the
KYTEs overhanging the edge of a flat surface
(Fig. A). Loosely fit the rear feet then move
up on to a level surface before fully tightening
to ensure the speaker will sit level in its final
position (Fig. B).
IMPORTANT: NEVER place the speaker face
down when fitting the feet to avoid damage to
the drive units.
CONNECTION
Ensure the colour terminals Red (+) and Black
(-) are connected to the correct terminals at
both loudspeaker and amplifier binding posts.
POSITIONING
The KYTEs can be used on stands, a sturdy
shelf or flat surface. Imaging and bass response
can be tuned by adjusting the distance of
the speaker from the rear wall. As with all
loudspeakers, this will be dependent on the
size of room, flooring and furnishings therefore
some simple experiments trying different
distances will help optimise the performance
to your surroundings. In general, more bass is
produced if the cabinet is positioned closer to a
structural wall.
KYTE STAND ADAPTOR
(OPTIONAL)
An optional metal base is available for
purchase, which will offer greater compatibility
with a wide range of third party loudspeaker
stands (see www.rega.co.uk for details).
REPLACING THE DRIVE
UNITS
In the unlikely event a drive unit needs to be
replaced, it is necessary to remove the front
fascia label to access the drive unit fixing
screws. A new adhesive front panel label will
be supplied as standard with any replacement
units. To remove the front panel label, we
recommend accessing via the unit that requires
replacement to prevent damage to the phenolic
cabinet. We recommend that any servicing is
carried out via a registered Rega dealer, you
can find your nearest Rega dealer on www.rega.
co.uk/dealers.
x2 (SUPPLIED)
21
x4 (SUPPLIED)
FIG. A
EN www.rega.co.uk
MOVE ON TO
FLAT SURFACE
BEFORE FULLY
TIGHTENING
FIG. B