Table des Matières
Publicité
TURNTABLE SETUP
•
Carefully unpack the turntable. Always
keeping it upright.
•
Place the turntable on a level surface.
•
Connect the power supply to the rear of
the turntable (1).
Connect the phono output (2) to INPUT 1
•
on the io amplifier (PHONO).
•
Remove the packing card (A) from beneath
the sub platter and fit the platter and mat.
•
Fit dust cover into rear brackets (3) on
plinth (4).
•
To automatically set the required
downforce, simply push the balance
weight (5) onto the rear of the tonearm (6)
until it fully reaches the stop point (B).
•
Carefully remove the stylus guard from
the Carbon cartridge (7).
Turn on the Planar 1 via the on/off switch
•
located on the left underside of the plinth
(8).
•
To change the RPM, simply move the drive
belt between the 331/3 and 45 steps of the
pulley as required (C).
•
Bias is automatically set on the RB110
tonearm, no setting is required.
LOUDSPEAKER CABLE
LOOK FOR
IDENTIFIER
(IDENTIFIER
MAY VARY,
SEE DIAGRAM)
DUST COVER
+
OR
1
5
A
B
LOCATED
STOP POINT
BENEATH
PLATTER
(9)
7
STYLUS GUARD
+
+
EN
www.rega.co.uk
331/3 RPM
45 RPM
C
+
-
Publicité
Table des Matières
