Getting Started; Charging The Battery - Bestway AQUAROVER FLOWCLEAR 58622 Manuel D'utilisation

GETTING STARTED

Charging The Battery

IMPORTANT NOTE: Fully charge the robot (about 5-6 hrs) before using it for the first time.
WARNING!
 Use only the original external adaptor and charging cable provided.
 Make sure the robot and the charging port are clean and dry before set-up.
 Make sure the robot is off by sliding the switch to the OFF position prior to charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Connect the adaptor cable to the charging cable. Align and insert the plug of the
charging cable into the charging port at the top of the unit.
3. Connect the external adaptor to the power source. Once the robot begins charging,
the indicator light on the external adaptor will turn red.
The indicator light on the external adaptor will turn green when the robot is charged.
Charge it for 5-6 hours for best performance.
Immediately disconnect the external adaptor from the power source if you detect any

of the following:
Offensive or unusual odor
-
Excessive heat
-
Deformation, cracks, leaks
-
Smoke
-
RED light - Charging
GREEN light - Charged
OFF
ON
7