Operation - Bestway AQUAROVER FLOWCLEAR 58622 Manuel D'utilisation

Robot de nettoyage de piscine autonome
Masquer les pouces Voir aussi pour AQUAROVER FLOWCLEAR 58622:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

WARNING!
Make sure the robot is off.
1.
Bring your robot to the side of your pool. NOTE: Do not place the robot in the pool
corner and against the pool wall as starting location. Unwrap the rope from the float (note
that there are side notches at the top and bottom of the stem, as well as a narrow slot at
the bottom). Allocate sufficient length of the rope that is equivalent to the pool depth plus
an excess of about 0.5 meters (1.6 feet) from the bottom of the float.
First, align and attach the rope to the side notches at the top as you wrap the rope around
the stem (step 1 & 2). Keep wrapping the rope around the top half of the stem until it
reaches the required length (step 3) Use your thumb to uphold the rope on the stem as
shown, then pull the rope down to the bottom slot to align and hook it to the notch (or
further down to the middle of the zigzag if necessary)(step 4). Last but not least, give the
rope a tug to ensure it is secured to the side notch on bottom as shown (step 5)
2. Slide the power switch to the ON position and the power indicator light will turn on.
ATTENTION: Motor activates only when the robot is submerged in water completely
Power indicator
light
(Green)
3. Immerse the robot into the water and operation will automatically begin as water level
covers the sensors at the top of the swivel head. Let the robot sink to the pool floor and
observe the cleaner's first forward and reversed movements across the pool bottom. If the
robot runs along the pool wall instead of perpendicular to it, reposition it to make sure that
its front/back faces the pool wall.
10

Publicité

Table des Matières
loading

Table des Matières