Float Replacement - Bestway AQUAROVER FLOWCLEAR 58622 Manuel D'utilisation

In order to maximize the cleaning efficiency, clean the debris compartment and the filter
cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the
cover and repeat the steps on the other side to lift the entire top cover to expose the
filter cover and filter plate.
2. Detach the filter cover and remove the debris from the compartment. It is recommended
to clean the filter cover net with splashing water. If brushing is deemed necessary, use
only a soft brush to clean it carefully and gently to avoid damaging it.
3. After cleaning, make sure that the filter cover is in place and the body top cover is
correctly installed and secured by the side clips.
CAUTION!
- Replace a damaged filter cover immediately with a new one before the next operation.
- Replace a damaged float immediately with a new one before the next operation.

Float Replacement

Use a screwdriver (not provided) to unscrew the 4 screws at on the top cover of the swivel
head. Untie the knot on the string to remove the damaged float. Ensure the round switch
is in place before sliding the string of the new float through the top cover and tying a knot
to keep it in place, and then re-install the top cover with screws.
12