Memphis Component Diagram - Memphis Pro Built-In ITC 3 Instructions

Part Name
Number
VG9501 Auger Motor
VG1967 Blower
VG1968 LCD Wiring Harness
VG0913(E) US Power Cable (Euro)
VG1971 Probe Jack
VG1972 Push Button
VG1975 Igniter
VG1976 Auxiliary Fan
VG1977 RTD
VG1980 Cook Lights
VG9012 WiFi Jack
VG9023 WiFi Antenna

Memphis Component Diagram

Description
This component rotates the auger to supply fuel into the burn pot
This component pulls air from the lower cabinet and into the firebox for combustion
Used to display Grill information and change grill settings
Power cable that plugs into 120VAC (US) or 240VAC (EU) wall outlet
This component is used to plug probes for monitoring meat temperature
This component is used to set the grill to cooldown, reset the controller, or put the
display to sleep
This component provide the initial heat during startup
This component supplies cooling for the power supply and logic boards
This component is used by the controller to determine the cook chamber
temperature
These components are mounted inside the cook chamber to provide light to the cook
area
Single conductor jack install in right panel connected to the logic board
2.4GHz WiFi antenna
14