Maintenance And Cleaning - Veripart VPSBS177Z Mode D'emploi

MAINTENANCE AND CLEANING

！ ！
Warning!
• Before cleaning, unplug the power plug first. Do not plug in or unplug
the unit with wet hands, because there is a risk of electric shock and
injury. Do not spill water directly on the fridge freezer combination
connectors, in order to avoid rust, electricity leakage or accidents.
Do not insert your hands into the bottom of the fridge freezer
combination, as there is a risk of being scratched by sharp metal
corners.
Internal cleaning and external cleaning
Any food residue in the fridge freezer combination is liable to produce bad
odours, so the fridge freezer combination must be cleaned regularly. The fresh
food compartment is usually cleaned once a month.
Remove all shelves, the crisper box, bottle racks, cover board, and drawers
etc., and clean them with a soft towel or sponge dipped in warm water or
neutral detergent.
Clean off any dust that accumulates on the rear panel and side plates of the
fridge freezer combination often.
After using detergent, be sure to rinse with clean water, and wipe dry.
！ ！
Warning!
• Do not use a hard bristle brush, steel wire brush, detergent, soap
powder, alkaline detergent, benzene, gasoline, acid, hot water or
other corrosive solvents to clean the cabinet surface, door gasket,
plastic decorative parts, etc., so as to avoid damage.
• Carefully wipe dry the door gasket, clean the groove using a thin
implement (i.e., a wooden chopstick) wrapped in cotton wool. After
cleaning, attach the four corners of the door gasket first, and then
embed it segment by segment into the door groove.
53