Maintenance And Cleaning - Veripart VPVR144NF Mode D'emploi

MAINTENANCE AND CLEANING

！ ！
Warning!
• Before cleaning, unplug the power plug first; Do not plug in or unplug
the freezer with wet hands, because there is a risk of electric shock
and injury. Do not spill water directly on the freezer in order to avoid
rust, electricity leakage and accidents. Do not insert your hands into
the bottom of the freezer, as there is a risk of being scratched by
sharp metal corners.
Internal cleaning and external cleaning
Any food residue in the freezer is liable to produce bad odours, so the freezer
must be cleaned regularly. The fresh food compartment is usually cleaned
once a month.
Remove all shelves, the crisper box, bottle racks, cover board, and drawers
etc., and clean them with a soft towel or sponge dipped in warm water or
neutral detergent.
Clean off any dust that has accumulated on the rear panel and side plates of
the freezer often.
After using detergent, be sure to rinse with clean water, and wipe dry.
！ ！
Warning!
• Do not use a hard bristle brush, steel wire brush, detergent, soap
powder, alkaline detergent, benzene, gasoline, acid, hot water or
other corrosive materials to clean the cabinet surface, door gasket,
plastic decorative parts, etc., so as to avoid damage.
• Carefully wipe dry the door gasket and clean the groove using a thin
implement (i.e. a wooden chopstick) wrapped in cotton wool. After
cleaning, attach the four corners of the door gasket first, and then
embed it segment by segment into the door groove.
52