ARENDO 304350 Mode D'emploi page 32

5.6 "AUTOSTART" - function
Using this function, you can pre-program the appliance to a desired time, so that
your appliance keeps the water or tea ready, e.g. in the morning for breakfast.
Fill the appliance with either water or tea and water. Always note the respective
maximum filling levels.
To do this, press the "AUTOSTART" button (1) until the blue status ring of the
button starts glowing.
The display now changes to the programming overview, which is indicated by the
small clock symbol at the top of the display.
In addition, two times are shown on the display. On the left is the
"CURRENT TIME", which represents the present time. On the right, you can see
the "START TIME" which represents the switch-on time.
To adjust the times, press and hold the "AUTOSTART" button (1) for 2 seconds.
The "CURRENT TIME / START TIME" indicators start flashing in the display.
The appliance now waits 20 seconds for your input. If there is no input during this
time, the appliance switches off and you will have to start the process again.
Now adjust the current time. To do this, use the "UP / DOWN" buttons of the indi-
vidual temperature setting (12), then the switch-on time using the "UP / DOWN"
buttons of the individual time setting (13).
When programming, pay attention to the 12-hour AM/PM classification (AM
=midnight to noon / PM = (12 noon to midnight).
Close or activate the "AUTOSTART" function by pressing the "ON/OFF" button (6).
If the programming of the AUTOSTART function is successful, the status rings of
the "AUTOSTART" (1) and "ON/OFF" (2) buttons glow continuously.
32
English