SoClean 2 Guide D'utilisation page 7

WARNING: Ensure the correct Clock time and Cycle
Start time are set on your SoClean 2 before using
your PAP machine. Pay particular attention to the
AM/PM setting if using 12-hr mode. Failure to do so
may result in the SoClean 2 device operating at an
unexpected time.
WARNING: In the event of loss of power to your
home or the SoClean 2 device, ensure the correct
Clock time and Cycle Start time are set on your
SoClean 2 before using your PAP machine. Failure to
do so may result in the SoClean 2 device operating at
an unexpected time.
WARNING: Do not physically alter the Hose Detect
Switches on your SoClean 2 device. Inspect the
Hose Detect Switches regularly for damage or
inability to move up/down. Failure of the Hose
Detect Switches on your SoClean 2 may result in
the SoClean operating at an unexpected time.
WARNING: Keep away from water sources including
rain, bathtubs, sinks, and pools. To clean, wipe with a
damp cloth. Do not submerge the SoClean device in
liquid or use chemical cleaners.
WARNING: Keep away from children. Do not place
any living thing inside the Disinfecting Chamber
during use.
WARNING: Do not inhale from the Injection Hose or
the Injection Hose outlet on the back of the device.
WARNING: Do not breathe through your PAP mask if
the SoClean is operating a Disinfecting Cycle
A000330-14_Rev A-SC1200 Manual_CA_0411.indd 3
WARNING: Do not use in explosive air environments,
near gas vapors, or other flammables, etc. Do not
place any flammable or ignitable items on top of the
SoClean 2.
WARNING: Keep the SoClean Lid closed until the
green status light illuminates (approximately 2 hours
after completion of Disinfecting Cycle).
WARNING: Do not remove gasket from Hose Detect
Switch slot.
CAUTION: The Lid Gasket is removable. Ensure that
the Lid Gasket is properly installed before operating a
Disinfecting Cycle.
WARNING: Do not dismantle the SoClean 2.
CAUTION: Do not place Neutralizing Pre-Wash
in the PAP reservoir. Neutralizing Pre-Wash is for
cleaning your PAP equipment only.
CAUTION: Please be sure the black Injection
Hose from the back of the SoClean is connected to
your PAP before operating your SoClean device.
WARNING: If a strong ozone odor is detected
when the SoClean is operating turn the SoClean
2 off by disconnecting the AC power adapterand,
inspect the SoClean 2 for visible damage, such as
cracks in the enclosure or tubing along with tubing
connections.
WARNING: Do not route your PAP hose through
both Hose Detect Slots while or after using your
PAP. This may result in the SoClean device running
at an unexpected time.
ENG | 3
4/11/19 1:35 PM