Included With Your Soclean - SoClean 2 Guide D'utilisation

INCLUDED WITH YOUR SOCLEAN

Number
1
2
3
4
5
6
7
6 | INCLUDED WITH YOUR SOCLEAN
A000330-14_Rev A-SC1200 Manual_CA_0411.indd 6
Part Name SKU
Removable
PN1214
Hose Slot Plug
Disinfecting
N/A
Chamber
Lid Gasket PN1215
SoClean Lid N/A
Cartridge Filter PN1207
Hose Detect
N/A
Switch
Neutralizing
PN1101
Pre-Wash
Description
This allows you to set up the SoClean 2 device on either the right or
left side of your PAP machine. Place this plug in the hose slot that
you don't use.
Place your mask in here when you wake up. Close the lid to ensure
that the daily automated disinfecting cycle runs.
Ensures tight seal around the Disinfecting Chamber when the
SoClean 2 lid is closed. Do not close the lid without this part in place.
Close the lid after you place your mask in the Disinfecting Chamber
to ensure that the daily automated disinfecting cycle occurs.
This Cartridge Filter converts ozone back into normal oxygen.
Remove outer plastic wrapping and blue tape prior to
installation. You can repurchase the Filter along with the Check
Valve as part of the Cartridge Filter Kit.
The Hose Detect Switch detects when the SoClean 2 is configured
for operation by detecting the presence of the hose in the hose slot
when the lid is closed. If no hose is detected, the SoClean 2 will
not run a disinfecting cycle. Hose Detect Switch operation can be
inspected by gently pushing down and releasing the gray plastic
switch and hearing an audible click. The switch should move freely
down and up when gently pressed.
The Neutralizing Pre-Wash removes any material or odor that could
react with ozone. Wash your PAP equipment following the PAP
manufacturers instructions before connecting the SoClean 2 device,
or when you receive a new mask, hose or reservoir.
4/11/19 1:35 PM