Pre-Maintenance Procedures; Preparing For Maintenance; Engine Maintenance; Servicing The Air Filter - Toro 58602 Manuel D'utilisation

Pre-Maintenance
Procedures

Preparing for Maintenance

1. Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark
plug.
Figure 16
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important:
Before tipping the machine,
allow the fuel tank to run dry through normal
usage. If you must tip the machine prior to
running out of fuel, use a hand fuel pump to
remove the fuel.

Engine Maintenance

Servicing the Air Filter

Service Interval: Every 25 hours
Yearly
1. Unclip the top of the air-filter cover.
g339525
1. Clip
2. Air-filter cover
2. Remove the air filter.
3. Inspect the air filter.
Note:
If the air filter is excessively dirty, replace
it with a new filter. Otherwise, gently tap the air
filter on a hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.
15
Figure 17
3. Air filter
g334791