Optional Kits; Accessories; Packing And Unpacking; Unpacking, Moving, Use And Storage - Blastrac BDC-3155HCA Manuel D'instructions

Operating manual BDC-3155HCA

Optional kits

Please contact the manufacturer's sales network for
information on optionals.
Instructions for installing the optional are included in the
conversion kit.
Use only supplied and authorised genuine spare parts.

Accessories

Various accessories are available; refer to the manufacturer's
accessory catalogue.
Use only genuine accessories supplied and authorised
by the manufacturer.

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Model
BDC-3155HCA 400/50

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
GB
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
WARNING!
WARNING!
Figure 2
A B C
(mm) (mm) (mm)
1350 700 1850
Setting to work - connection to the power
supply
Make sure there is no evident sign of damage to
■
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Connect the plug into a socket with a correctly
installed ground contact/connection. Make sure
that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection cables
must be protected against splashes of water.
■ Check that for proper connection to the electrical
mains.
■ Use the vacuum cleaners only when the cables
that connect to the electricity mains are in perfect
condition (damaged cables could lead to electric
shocks!).
Regularly check there are no signs of damage,
■
excessive wear, cracks or ageing on the electric
cable.
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
Kg
■ Only disconnect the cable from the electrical
mains by removing the plug (do not pull the cable).
200
■ Only replace the electric power cable with one of
the same type as the original: H07 RN - F. The same
rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
6/16
WARNING!
WARNING!
info@blastrac.eu