Sanyo DP42849 Manuel D'instructions page 22

UNIVERSAL REMOTE CONTROL, ADVANCED OPERATION
P M
ROGRAMMING
Your GXDB universal remote control includes the
ability to program any key (other than the SET
key) with a Macro function. Each one can be set
up to perform a pre-programmed set of sequen-
tial key presses with the press of one single key.
A macro can be used to control a home theater
operation, to set a favorite channel, or for other
multiple functions you would like to control with
one key press. Moreover, each Macro Key can
hold up to 15 key presses total.
NOTE: Programming a new macro over an existing one
erases the original macro.
PROGRAMMING A MODE INDEPENDENT MACRO
1.
Press and hold SET until the red LED blinks
twice, then release.
2.
Press 9 9 5. The LED blinks twice.
3.
Press the key you wish to assign a macro on.
4.
Enter the series of commands you want the
macro to execute (up to 15 commands).
5
. Press and hold SET until the red LED blinks
twice, then release.
Now, when you press the preset macro key , the
remote sends the series of commands you have
entered, regardless of what mode you are in. For
example, you could program a macro key to turn
on both your TV and cable box and select a par-
ticular channel. To clear the macro, repeat steps
1-5 above, but do not enter a series of commands
at step 4.
PROGRAMMING A MODE-DEPENDENT MACRO
1.
Press the device mode key (DVD, STB, or AUX).
2.
Press and hold SET until the LED blinks twice,
then release.
3.
Press 9 7 8. The LED blinks twice.
4.
Press the key you wish to assign a macro on.
5.
Enter the series of commands you want the
macro to execute (up to 15 commands).
6
. Press and hold SET until the red LED blinks
twice, then release.
22
Need help?
ACROS
www.sanyoctv.com
Now, when you press the macro key , the remote
sends the series of commands you have entered,
but only if you are in the mode you selected in
step 1. For example, you could program the
macro key to turn on both your TV and cable box
and select a particular channel, but only if you are
in TV mode. If you are in DVD mode, this key does
not execute the macro you set up in TV mode. To
clear the macro, repeat steps 1-6 above, but do
not enter a series of commands at step 5.
IMPOTANT FACT:
"TV" mode is dedicated only to a Sanyo TV. By press-
TV
ing the key on your remote control the Sanyo TV
control code is reactivated.
1-800-877-5032