Hotpoint Ariston SI C35 CKG Mode D'emploi page 22

it en
Make sure that all adhesive parts have been
removed from the soleplate with a dampened soft
cloth and eliminate any residues or particles from
the manufacturing process, by repeatedly filling and
emptying the water reservoir.
When switching on the iron for the first
time, you may notice an unpleasant odour, a
little smoke and some impurities that will
disappear in a few minutes. When using the steam
function for the first time, do not direct the steam
jet on the garments because of the possible
presence of manufacturing residues in the steam
dispenser.
Never add any perfume, vinegar, starch,
scale-removing agents, ironing products or
other chemicals in the water reservoir - unless
recommended by Hotpoint-Ariston. Never use
contaminated water or coming from driers,
accumulators or air conditioners.
Filling the water reservoir (A)
We recommend using demineralised water.
Before filling the iron with water, make sure that
the iron is switched-off and disconnected from the
electrical socket.
1. Set the steam regulator (3) to Off.
2. Tilt the iron in such a position to make water
entrance easier.
3. Open the lid of the filler hole (15) and fill the water
reservoir using the water measurer supplied with
the iron. Never fill the water reservoir above the
maximum water level (12).
4. Close the lid of the filling hole.
USING THE IRON
Selecting the temperature
and adjusting the steam (B)
1. Connect the plug of the appliance into a
grounded socket (220-240V).
2. Use the temperature control (5) to select the
desired temperature. If you go from a lower
temperature to a higher temperature, the
temperature indicator light (6) light up until the
selected temperature is reached.
3. When the iron reaches the set temperature, an
acoustic signal is emitted and the temperature
indicator light goes off.
22
All manuals and user guides at all-guides.com
4.
5.
USE
Ironing without steam (C)
1.
2.
Steam ironing (D)
1.
2.
We recommend to check the garment label
in order to identify the fabric type. In case of
doubts, it is recommended not to use the spray
function and iron a hidden corner in order to
determine the most appropriate temperature
and avoid damaging the fabric. In case of very
delicate fabrics, such as silk, wool, and synthetic
materials, iron the garment inside out to prevent
shiny marks. Start ironing the garments that
require a lower temperature, such as synthetic
fabrics.
Fabrics with this symbol on the label
must not be ironed.
GARMENT TEMPERATURE
FABRIC TYPE
LABEL INDICATION
synthetic
silk
mixed cotton
wool
mixed wool
cotton
linen
jeans
Select the steam level with the steam regulator
(3) or move it to Off to iron without steam. When
steam ironing, make sure that the water level in
the reservoir is at least ¼.
Set the steam regulator (3) to Off (=no steam).
Select the recommended ironing temperature
with the temperature control (5) (see step B and
chapter "Using the iron", section "Selecting the
temperature and adjusting the steam").
Check that the water level in the reservoir is
higher than ¼.
Select the appropriate steam with the steam
regulator (3) and the recommended ironing
temperature with the temperature selector (5)
(see step B and chapter "Using the iron", section
"Selecting the temperature and adjusting the
steam").
Using the ECO function you can have a 30% of
STEAM
INDICATION
MIN
LINEN