Husqvarna PG 690 Manuel D'utilisation page 42

To set the support wheel in position for short
distance transportation
1. Put the support wheel frame (A) against the product
frame.
C
B
a) If it is necessary, loosen the screw at the front of
the support wheel frame to loosen the wheel.
This makes it possible to put the support wheel
frame at the correct angle against the product
frame.
2. Push the support wheel pin (B) into the support
wheel and lock the support wheel pin with the cotter
pin (C).
3. Remove the support wheel in the opposite
sequence.
To set the support wheel in operation position
The operation position is also used for long distance
transportation.
1. Put the support wheel to vertical position.
2. Lower the support wheel against the product frame
(A).
42
A
A
C
B
3. Push the support wheel pin (B) into the support
wheel and lock the support wheel pin with the cotter
pin (C).
4. Remove the support wheel in the opposite
sequence.
To adjust the height of the support wheel
1. Set the support wheel in position for short
transportation distances. Refer to
wheel in position for short distance transportation on
page 42 .
2. Turn the handle at the front of the support wheel to
lift or lower the support wheel.
To move the product with the support wheel
1. Set the support wheel in position for transportation
short distances. Refer to
position for short distance transportation on page 42 .
2. Lower the support wheel to lift the grinding head
from the ground. Refer to
support wheel on page 42 .
3. Move the product manually or with the remote
control.
To move the product up and down a
ramp
WARNING: Be very careful when you move
the product up and down ramps with the
motor on. The product is heavy and there is
a risk of injury if the product falls or moves
too quickly.
WARNING: For ramps with a steep slope,
always use a winch. Do not walk or stay
below the product. Do not stay in the
product risk area. Refer to
on page 10 .
WARNING: Do not move the product up and
down a ramp when the remote control
battery has a low state of charge. The
product can suddenly get power failure.
To set the support
To set the support wheel in
To adjust the height of the
Work area safety
1163 - 004 - 01.10.2020