Teka DG3 ISLA Manuel D'instructions page 10

Dear Customer,
Congratulations on your choice. We are certain
that this modern, functional and practical device
made with first rate quality materials will fully
satisfy your requirements.
Please read all the sections in this INSTRUCTION
MANUAL before using the hood for the first time
in order to obtain maximum performance from
the device and avoid faults which may arise from
incorrect use as well as minor problem solving.
For optimal performance, the external duct should
not exceed FOUR METRES, have more than two
90 ° angles and its diameter should be at least
Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the
interior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
grease in the hood and metal
filters may cause dripping and fire
risks, therefore it is necessary to
wash the inside of the hood and
the metal filters at least once a
month.
•This device can be used by
children aged 8 and over and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge,
if they have been given supervision
or proper training in the safe use of
the device and if they understand
the dangers involved. Children
should not play with the device.
Cleaning and maintenance should
be performed by the user and not
by unsupervised children.
•Check that the power voltage and
frequency match those indicated
on the label located on the inside
of the hood. A suitable earth must
be connected (except for Class
II devices, marked with
technical data plate).
•For installation, a connection
method isolated from the fixed
installation should be incorporated,
in accordance with installation
regulations (adjusted to the strength
to be endured and with a minimum
opening between the contacts of
3mm) under overvoltage category
III conditions, for the emergency
shutdown, cleaning
replacement. In no event should
the earth pass through this switch.
This switch can be replaced with
a plug if it is accessible in normal
use.
•If the power lead is damaged
it must be replaced by the
manufacturer,
service or by qualified personnel
in order to avoid potential danger.
•Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or
other fuels.
on the
or light
its after-sales