Setting The Clock - JVC RC-EX30B Manuel D'instructions

SETTING THE CLOCK

Before operating the unit any further, first set the clock
built in this unit.
The clock uses 24-hour indication.
1 Press STANDBY/ON
is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK SET for more
than 2 seconds.
The hour digits start flashing.
3 Press 4 or ¢ to adjust the hour, then press
PROGRAM/CLOCK SET.
The minute digits start flashing.
4 Press 4 or ¢ to adjust the minutes, then press
PROGRAM/CLOCK SET.
1 3,4
PUSH
REMOTE
DISPLAY
SENSOR
to turn off the unit, if it
2,3,4 1 2,3,4
STANDBY/ON
DISPLAY
HBS/
PRESET EQ
FM MODE
/BEAT CUT
UP
PRESET
DOWN
RM-SRCEX30J REMOTE CONTROL
Note:
If there is a power failure, the clock loses the setting and
is reset to "0:00." The clock indication will keep flashing
until you set the clock again.
To show the clock when the unit is on
Press DISPLAY.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
DISPLAY
Main unit
Note:
Operating the unit while clock indication is displayed
changes the display to the normal indication.
3,4
CD/ TUNER/
RANDOM BAND TAPE
1 2 3
4 5 6
7 8 9
OVER
0
PROGRAM/ +
INTRO
CLOCK SET
REPEAT MUTING GROUP
–
VOLUME
DISPLAY
Remote
7