Hilti SB 4-A22 Manuel page 29

7.1 Bandsaw is not in working order
Malfunction
No response from the
LEDs.
1 LED flashes.
4 LEDs flash.
7.2 Bandsaw is in working order
Trouble or fault
The tool does not de-
velop full power.
8 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences:
The burning of plastic components generates toxic fumes which may present
a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution.
Careless disposal may permit unauthorized and improper use of the equipment.
This may result in serious personal injury, injury to third parties and pollution of
the environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children.
Do not disassemble or incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance
with national regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can
be recycled. The materials must be correctly separated before they can be recycled.
In many countries, your old tools, machines or appliances can be returned to Hilti for
recycling. Ask Hilti Service or your Hilti representative for further information.
Printed: 19.10.2016 | Doc-Nr: PUB / 5310781 / 000 / 00
All manuals and user guides at all-guides.com
Possible cause
The battery is not correctly
inserted.
The battery is empty.
Safety lock not pressed.
The battery is discharged.
The battery is too hot or too
cold.
Bandsaw momentarily over-
loaded.
Bandsaw too hot.
Tool is blocked
Possible cause
The control switch is not
fully pressed.
The battery is discharged.
Action to be taken
▶ Push the battery in until
it engages with a double
click.
▶ Charge the battery.
▶ Press the safety lock.
▶ Change the battery and
charge the empty battery.
▶ Bring the battery to the
recommended working
temperature.
▶ Release the control switch
and then press it again.
▶ Allow the bandsaw to cool
down.
▶ Check whether the saw
blade is fitted correctly
and/or damaged.
Action to be taken
▶ Press the control switch
fully.
▶ Change the battery and
charge the empty battery.
English 23