Maintaining Your Tile Saw; Accessories; Troubleshooting - skilsaw 3540 Consignes D'utilisation/De Sécurité

SM 2610028638 12-14_3540 12/23/14 9:01 AM Page 15
For your own safety, turn switch "OFF" and
W RNING
remove plug from power source outlet be-
fore maintaining or lubricating your saw.
The cord and the tool should be wiped with a dry clean
cloth to prevent deterioration from oil and grease.
Certain cleaning agents and solvents can
W RNING
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
ammonia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
Turn switch "off" and always remove plug from the power source before trouble shooting.
W RNING
TRoUBle
will not start
Does not come
up to speed
excessive vibration

maintaining Your Tile Saw

maintenance

Troubleshooting

pRoBlem
Power cord is not plugged in.
Fuse or circuit breaker tripped.
Cord damaged.
Burned out switch.
Extension cord too light or too long.
Low house voltage.
Tile blade out of balance.
Tile blade bolt not tight.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
All repairs, electrical or mechanical, should
W RNING
be attempted only by trained repairmen.
Contact the nearest Factory Service Center or Authorized
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.

accessories

Use only recommended accessories. Follow
W RNING
instructions that accompany accessories.
Use of improper accessories may cause hazards.
RemeDY
Plug in.
Replace fuse or reset tripped circuit breaker.
Have cord replaced by an Authorized Skil Service Center
or Service Station.
Have switch replaced by an Authorized Skil Service Center
or Service Station.
Replace with adequate cord.
Contact your electric company.
Discard tile blade and use different one, see page 11.
See "Tile Blade Installation", page 11.
15.