Operation; High/Low Heat Setting - Klarstein BORNHOLM CURVED Mode D'emploi

OPERATION

Starting
1. Take out the heater from the carton carefully. Please save the carton for off-season
storage.
2. Make sure the power switch is in the OFF position before plugging it in.
3. Ensure the heater is fully assembled according to the mounting guide.
4. It is better not to use the same electrical connection at the same time as other
devices with high power consumption in order to avoid overloading the circuit.
Turn on
Connect the unit to the power supply and switch it on. The unit is now in standby mode
and the display shows the current time. The button symbols (13, 14, 15, 16) light up.
After 10 seconds all lights go out again except for the indicator light of the On/Off
button (13).
Time setting
Press and hold the setting button (16) and the arrow up button (15) simultaneously for
three seconds. The week indicator (6) flashes and the time setting is active. Use the
arrow buttons (14, 15) to select a day of the week. Press the setting button (16) and the
hour indicator (5) will flash. Select the hour with the arrow buttons (14, 15). Press the
setting button (16) to go to the minute setting. Use the arrow buttons (14, 15) to select
the minute and confirm the set time with the setting button (16) or wait 5 seconds and the
settings will be saved automatically.
Temperature setting
Press the setting button (16). The temperature indicator (17) flashes. Then select the
temperature with the arrow buttons (14, 15). Confirm the setting with the setting button
(16) or do not make any further entries for 5 seconds so that the settings are accepted
automatically. (With the remote control: Set the desired temperature with the arrow
buttons (14, 15) and save the setting with the OK button (22).)

High/Low heat setting

Use the arrow down button (14) to select the low heating level. In the display the symbol
appears.
Use the arrow up button (15) to select the high heating level. In the display the symbol
appears.
Alternatively, press the shifting button (21) on the remote control to change between
high and low heating level.
EN
23