Tool Specifications; Safety Instructions - CLAS OP 1404 Mode D'emploi

OP 1404
VIBRATION GLOW PLUG REMOVAL KIT 1/4"

TOOL SPECIFICATIONS

Square drive :
Free speed :
Torque Setting :
Air inlet :
Hose size :
Air pressure :
Average Air Consumption :

SAFETY INSTRUCTIONS

CAUTION: It is required to READ, UNDERSTAND and KEEP these instructions. Failure to comply
with all of the instructions below may result in serious injury.
1. Keep your workspace clean and well lit.
2. Do not use power tools in explosive atmospheres, such as in the presence of liquids, gases or
combustible dust. The power tool creates sparks that can ignite dust or vapours.
3. Disconnect the tool before performing maintenance or when not in use.
4. High sound levels can lead to permanent hearing loss. Use hearing protection throughout the use of the
tool.
5. Maintain a balanced body position and a good sitting position.
6. Slipping, tripping or falling is a major cause of serious injury or death. Be careful with excess hose left on
the floor in the walkway or work area.
7. Repetitive movements, uncomfortable positions and exposure to vibrations can be harmful to hands
and arms. In case of numbness, tingling, pain or bleaching of the skin, stop using the tool and consult a
doctor.
8. Always wear impact-resistant face and eye protection when operating the tool or near the use, repair,
maintenance or replacement of accessories.
TOOL USE AND CARE
1. Use a support handle or other practical means to secure and support the work piece on a stable
platform.
2. Do not force the tool. Always use the right tool for your application. You will get better and safer results
with the right tool combined with the right operating rate.
3. Disconnect the air supply before making any adjustments, changing accessories or storing the tool.
Always disconnect the air supply before performing any inspection, maintenance or cleaning of the tool.
4. Use only the accessories recommended by the manufacturer for your model.
5. Use the lever under the trigger to select forward (clockwise) or reverse (counterclockwise) rotation.
6. Do not leave the tool unattended when connected to an air supply.
7. Use only compressed air.
1/4" (6mm)
10.000 RPM
1 : 10Nm ; 2 : 20Nm ; 3 : 30Nm ; 4 : 40Nm
1/4"
3/8" I.D. (10 mm)
90 PSI (6.2 Bar)
4 CFM (113L/Min)