Inserting The Batteries; Setting The Remote Control - Philips SRU 4010/10 Mode D'emploi

Instructions for use
All manuals and user guides at all-guides.com
Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2. Installing the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6

Inserting the batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Testing the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Setting the remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6

3. Keys and functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Code list of all brands / equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52-58
Information to the Consumer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
1. Introduction
Congratulations on your purchase of the Philips SRU 4010 universal remote control.
After installing the remote control it can operate the most-used functions of almost any
brand of TV.You can find information about how to prepare this remote control for use in
the chapter 'Installing the remote control'.
2. Installing the remote control
Inserting the batteries
1
Press the cover inwards and slide it in the direction
of the arrow.
2
Place two AAA type batteries into the battery
compartment, as shown.
3
Slide the cover back and click it firmly into place.
Testing the remote control
The remote control has been programmed to operate most Philips devices. Because the
SRU 4010 may use different signals for each brand and even for different models of the
same brand, it is advisable to test whether your TV responds to the SRU 4010.
The example below instructs you how to do this.
1
Turn your TV on manually or use the original remote control.Tune to channel 1.
2
Check whether all the keys are working.
For an overview of the keys and their functions,
see '3. Keys and functions'.
– If the TV responds as it should to all of the key commands
the SRU 4010 is ready for use.
• If the TV does not respond at all or not to all of the key commands, follow
the instructions under 'Setting the remote control', or for online setup go to:
www.philips.com/urc.
Setting the remote control
This is only necessary if your TV does not respond to the SRU 4010.
If that is the case, the SRU 4010 does not recognize the brand and/or model of your TV
and you need to program the remote control to do so.
You can set the remote control either automatically or manually.
4