Hilti TE 6-A22 Mode D'emploi page 13

2.5 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a cordless rotary hammer drill. It is designed for drilling in steel, wood and masonry,
for hammer-action drilling in concrete and masonry, and for driving and removing screws. The product can
also be used for light chiseling work on masonry and surface finishing on concrete.
▶ Use only Hilti lithium­ion batteries of the B 22 series with this product.
▶ Use only the Hilti lithium-ion batteries from the B22 series for this product.
3.3 Lithium­ion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights up.
1 LED blinks.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
*2166350*
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
£
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
2166350
Dust shield
chuck
Insert tool unlocking device
Depth gauge
Function selector switch
Forward / reverse selector switch with safety
lock
Control switch
Grip
Battery release buttons
Charge status and fault display (Li-ion bat-
tery)
Battery
Connection for the TE DRS-6-A(02) dust re-
moval module
Side handle
Light to illuminate the work area
English 5