Publicité
Les langues disponibles
Les langues disponibles
REAR PARKING SENSOR PUNCH TOOL KIT PSA/RENAULT/DACIA
OC 9120
(14 PCS)
INTRODUCTION
It is compulsory to read this instruction manual before starting any kind of action.
The proper operation and full compliance of this product's performance is guaranteed only if all the
instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses other than those described herein.
Use protective work gloves, protective footwear, hard hat and safety goggles.
Misuse:
• This product should only be used as described in this documentation; any other use is considered
improper.
• The manufacturer accepts no responsibility for any damage caused by the incorrect or unreasonable use
of the equipment.
• Moreover, misuse shall also void the warranty.
Take care of your tools:
• Be sure to store your tools in a clean state.
• Place the tools inside their original package.
DESCRIPTION
The tool set described in this manual is used to make clean holes in plastic bumpers without burrs. This is
necessary when the replacement bumper supplied by the manufacturer does not have the holes for mounting
the parking sensors.
According to some manufacturers' repair instructions, holes should be drilled only after painting to guarantee,
once repaired, an appearance as close to the original as possible.
Furthermore, the centering pins contained in the tool set ensure the correct fixing and alignment of the sensor
supports during fastening (welding/gluing).
The OEM numbers shown are used only for assigning technical data and fields of use!
Publicité
