CLAS DM 2000 Mode D'emploi page 23

DM 2000
AUTOMATIC TYRE CHANGER 13"-28" WITH HELPER ARM
Do the adjustment as follow steps, if the horizontal arm does not move smoothly, or not lock well.
• Remove the cover on the post.
• Adjust the screw M6 on two sides by spanner, meanwhile push the horizontal arm till it can move smoothly, then
tighten the nut
• Adjust the screw in the middle by spanner, lock the horizontal arm and observe the change, till it can only move
in the range of 3-4mm, then tighten the nut.
23