CLAS DM 2000 Mode D'emploi page 22

DM 2000
the gauge does not exceed the manufacturer's limit. And in reference with the condition of the tyre, if the in ation
pressure is high, press the de ating control button on the pressure gauge to de ate the air.
The application of the assistant in ation
The unit is only needed for tubeless tyres, and it is necessary to wear the protection glasses during the operation.
When in ate the dif cult tubeless tyres, locking the tyre on the turntable(V), and connect the in ation hose (Z) with
the valve, then move the bead bottom upwards a little by hands, step the pedal U several times to rst position,
then to the second position, and enable the valve on the turntable de ate(V), in the meantime release your hand
slightly from the tyre continuously step the in ation control pedal (U) to rst position, to in ate till the setting pressure
shown on the tyre.
MAINTENANCE
Only the trained operator can do the maintenance.
It is necessary to do the maintenance in accordance with this manual periodically, to correctly use the machine and
prolong the working life of the machine. Otherwise the operation and the reliability maybe affected, and it may
injury the operator or the third person near the machine.
Note: Shut off the power and air source before any maintenance, and release all the compressed air from the
machine.
Keep the machine and the working area clean, prevent any dust from touching the moving parts.
Operation:
• Clean and lubricate the turntable (V) and the clamps (W) and its moving track with diesel oil weekly; clean the
vertical B, and keep it in normal working condition.
• Check the oil level in the air-container periodically. If it needs to be lled, then ll the20# oil. Step the pedal (P)
5-6times and the oil should drop one drop, otherwise adjust the oil control screw.
• Check and screw down all the connecting parts and all the bolts periodically.
• Keep the horizontal arm clean and lubricate it periodically to make it move smoothly.
• Lubricate all the connecting surface that may bring the displacement and attrition with oil weekly.
• Prepare a water segregator near the air-compressor, reduce the amount of the water in the compressed air.
• Check and adjust the tension of the driving belt, to make sure that the turntable can running well.
Note: Shut off the power and air sources before the operation.
Loose the screw on the left panel of the machine to demount the panel, and then adjust the nut on the motor to loose
and tighten the belt. (Fig. 2)
Do the adjustment as follow steps, if the vertical shaft does not lock well.
1.Shut off the pneumatic supply.
2. Demount the vertical arm (B) cover.
3. Adjust the nut near the thread rod by spanner, or lock the screw at back of the
locking plate.
4.Connect the pneumatic supply and observe the locked position, the vertical arm
(B) rise up for 3-4mm
22
AUTOMATIC TYRE CHANGER 13"-28" WITH HELPER ARM