Ts 800 Beltpack Transmitter - Beyerdynamic Opus 800 Notice D'utilisation

All manuals and user guides at all-guides.com
3.

TS 800 Beltpack Transmitter

3.1 Controls and Indicators
(1) AF input socket, 4-pin connection for microphones (lavalier, headsets). There are 5
different connections (refer also to chapter 3.5 AF Connection).
(2) ON/OFF switch (ON = switch to "ON"-position; OFF = switch to "OFF"-position).
Switch off the transmitter when not in use.
(3) Battery status LED to indicate the power on / off and battery status.
(a) When the beltpack transmitter is switched on this LED will flash for a moment to
indicate the normal battery status.
(b) When the LED stays red after having switched on the transmitter the battery is too
weak and must be replaced.
(4) Transmitting antenna.
(5) Housing.
(6) LC-Display.
(7) Infrared receiving diode for ACT function.
(8) Gain control to adjust input gain.
(9) GT/MT switch: When you use electric guitars this switch must be in the "GT"-position.
In the GT mode the gain control is deactivated. Switch to the "MT"-position when you
use condenser and wired microphones. In the MT mode the gain control is activated.
(10) Battery compartment and cover for two 1.5 V batteries (AA).
(11) Removable belt clip can be rotated 360°. To remove use a screwdriver at a 45° angle.
40