All manuals and user guides at all-guides.com
5.
Trouble Shooting
5.1
NE 800 Diversity Receiver
Problem
No function
• Power supply is interrupted, power
supply unit is not connected to the mains
and / or to receiver
No reception
• Transmitter is not switched on
• Transmitter works on a different
channel
• Defect in the antenna cables with
remote antennae
Distorted sound
• Input amplifier of the connected mixer is
overloaded
"CLIP" indication on
• Transmitter is overloaded
receiver
No sound, RF-indication
• Wrong indication caused by strong
is okay, AF- indication is
interference signals
missing during modula-
• No microphone connected to TS 800
tion
beltpack transmitter
5.2
Handheld and Beltpack Transmitter
Problem
No function
• Transmitter and receiver have different
frequencies
• Insufficient battery voltage
• Poor battery contact, battery inserted
incorrectly
No RF-indication at
• Transmission distance between transmitter
the receiver
and receiver is too great
Noise/chirping
• Interference from other transmitters
• Two transmitters are on the same
frequency
• Battery of the transmitter is too weak
46
Possible Cause
• Connect the receiver to AC power
• Switch on the transmitter
• Adjust the correct frequency with the
ACT function
• Check the antenna cables
• Use the gain control of the mixer or
adjust the volume
• Reduce the sensitivity of the
transmitter or increase the distance
between microphone and sound
source.
• Choose another receiving channel
• Connect a suitable microphone
Possible Cause
• Check if transmitter and receiver
have the same frequency
• Replace the batteries or recharge
them, if you use rechargeable
batteries
• Check the battery and insert it again
• Reduce the distance between
transmitter and receiver
• Switch off the other transmitters
• Change the frequency of one
transmitter
• Replace the batteries
Solution
Solution