Dmx512 Connections - Nicols PAR LED 188 FCB II Notice D'utilisation

7. Manuel Mode
Press the MENU button up to when the
will blink. Use DOWN and UP button to choose the red, green, blue or white mode. Once the mode has been selected, press
the ENTER button to setup or automatically return to the main functions without any change after 1 minute. To go back to the
functions without any change press the MENU button again.
8. AUTO-TEST
Self-Test
Press the MENU button up to when the
built-in programmer for self-test. To go back to the functions press the MENU button.
9. Use of machine time
Fixture Hours
Press the MENU button up to when the
number of working hours of the unit. To go back to the functions press the MENU button.
Temperature
10.
Select the Tenp menu, press the ENTER key to determine. You can see the machine light board temperature/degree.
Not to make any changes, wait a minute to automatically exit the menu and save. The main menu, please press the MENU
button.

DMX512 Connections

The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
Termination reduces signal errors and avoids signal transmission problems and interference. It is always advisable to connect a
DMX terminal. (Resistance 120 ohm 1 / 4W) between pin2 (DMX-) and pin3 (DMX+) of the last fixture.
All manuals and user guides at all-guides.com
is showing on the display. Pressing ENTER button and the display
is blinking on the display. Pressing the ENTER button and the unit will run the
is blinking on the display. Pressing ENTER button and the display will show the