Functional Description - ITC SCMS12UD Manuel De L'utilisateur

SPECIFIC SAFETY PRECAUTIONS FOR MITRE SAW
CUT ONLY WHILE SLIDING THE CUTTING HEAD FROM FRONT TO BACK.

The material must be placed firmly against the fence and table. The rotation
of the saw blade should force workpiece down against the table and rearward
against the fence during the cut. Cutting in the other direction; i.e. pulling the
cutting head and blade towards you during the cut, may cause the blade to
climb on top of the workpiece and create a kickback. When this happens, the
cutting head may jump out of your hand or the workpiece fly loose and cause
serious injury.
DON'T START THE SAW WITH THE BLADE IN CONTACT WITH ANY

SURFACE. The saw head may bounce up or kick back violently and cause
injury.
IF MAKING A CUT USING ONE HAND TO HOLD THE SAW, ensure the free

hand is clear of the cutting area.
WARNING: The warnings, cautions, and instructions in this manual cannot cover
all possible conditions and situations that may occur. It must be understood
by the operator that COMMON SENSE AND CAUTION ARE FACTORS THAT
cannot be built into this product, but MUST BE SUPPLIED BY THE OPERATOR.
SPECIFICATIONS
Voltage: 120 volts AC, 60Hz.

Current rating: 15 amps

4200 rpm, no-load speed

Electronic brake

12" carbide tipped 80 tooth saw blade

5/8" arbor

Bevel cuts up to 45° left

Mitre cuts up to 45° left & 45° right with positive stops at 0°, 15°, 22.5°, 30°, &

45° left and right
Cut capacities:

Cross-cut @ 90°: 100 mm H x 310 mm W (3.9" x 12.2")
Mitre-cut @ 45°: 100 mm H x 215 mm W (3.9" x 8.5")
Cross-cut Bevel @ 45°: 55 mm H x 310 mm W (2.2" x 12.2")
Compound Cut @ 45° & 45°: 55 mm H x 215 mm W (2.2" x 8.5")
Included: blade wrench, dust bag, hold-down clamp and table extensions

Tool weight: 17.8 kg (39.2 lb.)

Packed Weight: 26 kg (57.3 lb.)

ASSEMBLY
REMOVE ALL THE PARTS FROM THE BOX
Your Sliding Compound Mitre Saw is fully assembled in the carton
with the exception of some small accessories.

FUNCTIONAL DESCRIPTION

A. Mitre scale
B. Table side extension
C. Slip-lock bevel adjustment lever
D. Hold down clamp
E. Carriage slide lock screw
F. Dust bag
G. Trigger switch
H. Blade guard
I. Head locking button
J. Mitre clamp screw knob
K. Fence
L. Kerf plate
M. Pointer
N. Mitre table adjusting handle
4
012026
!
!