PEUGEOT ENERGYSaw-254STB Manuel D'utilisation page 12

description of the sliding mitre saw
1
1. Front carrying handle
2. Upper blade guard
3. Locking lever handle
4. Guiding handle
5. ON / OFF switch
6. Security switch for starting
7. Base
8. Lock/trigger table handle
9. Table Insert
10. Bevel lock/unlock handle
11. Scale indicator table
12. Fixing holes
14. Left table extension
15. Sliding guide
16. Clamp
17. Bevel scale
18. Blade
19. Motor
20. Slides
21. Slides lock buttons
22. Cutting depth settings
23. Rear carrying handle
24 - Table extension with stop
starting with your mitre saw
2
Lock the cutting head:
To unlock the cutting head down position:
Pull the cutting head down.
Remove the locking pin (1).
Move the cutting head to the upper position.
When transporting or storing the miter saw, the cutting head must always be locked in the down position:
Press the cutter head to lower position and engage the locking pin (1) into the locking notch.
Fixing the machine to a bench: Use the 4 holes (2 and 3) on each side of the machine to fasten it to the workbench.
Installation of the press: place the press in the hole behind the guide slide (4).
The miter saw is supplied with two extensions table with retractable stop. Insert top extensions (6) in the holes on
each side of the table, and lock with the locking knob (5)
Unlocking of the slide: Loosen the locking knob of the slide (7). Systematically block the sliding carriage when trans-
porting or storing the miter saw.
Installation of dust bag: To install the dust bag (9), press the ears of the metal clamp (8).
Put the bag opening on the elbow, and then release the metal collar ears.
Rear table support: Insert the two axes of the support (10) into the holes on the back of the machine (11 and 12) and
tighten the 2 screws under the table. Warning: this support is important to ensure the stability of the machine.
132049-EnergySaw-254STB-Manual.indd 12
All manuals and user guides at all-guides.com
Transporting the saw:
To avoid damage, do not carry the miter saw by
the handle of the blade head. ALWAYS use the
carrying handles (1) and (23).
en
9/09/15 17:10:36