Ec Declaration Of Conformity - LTC Evolution 15 Instructions Originales

The motor works but the
spray does not reach the
pressure or spraying is
irregular.
The motor does not stop
when the handle is released.
The handle does not close
The motor runs
intermittently when
spraying.
8
WARRANTY
Our goods have a two year warranty, from the date of purchase by the user, against any manufacturing or material defect. The
warranty is strictly limited to free replacement of parts that our services consider defective. The warranty shall not apply in case
of improper use of our materials, disassembly and/or alterations performed to our devices, and to those parts of normal wear and
tear that require maintenance The warranty shall not apply in case of negligence, imprudence and irrational use of the material.
Dispatch and transportation costs of parts under warranty as well as workmanship that were not performed in our factory shall be
borne by the user. To invoke this warranty, send us the part subject matter of the claim, carriage free, together with the receipt or
the purchasing invoice.

EC DECLARATION OF CONFORMITY

9
We,
Goizper Group - C/Antigua 4 – E-20577 Antzuola - Spain
declare under our sole liability that this product complies with Directives 2006/42/EC and 2009/127/EC in compliance with
the harmonised EN ISO 19932-1:2013; EN ISO 19932-2:2013; EN ISO 14982:2009.
Antzuola, March 2021.
Aitziber Uriarte, Technical Director
The amount of fl uid in the sprayer
The recommended working positions for each nozzle
Cleaning the suction fi lter of the tank (Ref. 1251)
Hydraulic connections and leakages
Air in the hydraulic circuit
The condition of the nozzle
Check if the pump or the electronics are damaged
The amount of fl uid in the sprayer
Cleaning the suction fi lter of the tank (Ref. 1251)
Air in the hydraulic circuit
Hydraulic connections and leakages
Check if the pump is damaged
The condition of the joints
The selected nozzle has a nominal fl ow rate less than
that recommended in the nozzle table.
Cleaning the nozzle, its fi lter and handle fi lter. [3.5]
Fill the sprayer with the product to be
sprayed
Use the nozzles and work positions
recommended in the nozzle selection tables
T.1 and T.2.
Clean the fi lter if necessary
Tighten any joint if necessary
Stop the motor and restart the equipment to
spray a few seconds with the lance pointing
upwards
Replace the nozzle if damage is perceived
or considerable wear and tear is discerned.
Contact the distributor
Fill the sprayer with the product to be
sprayed
Clean the fi lter if necessary
Stop the motor and restart the equipment to
spray a few seconds with the lance pointing
upwards
Tighten any joint if necessary
Contact the distributor
Change and grease the joints or the fi lter
with joints.
Use the nozzles and work positions
recommended in the nozzle selection tables
T.1 and T.2.
Clean the fi lters if necessary