Waeco MagicSpeed Instructions De Montage Et De Service page 22

MS-ir2 24/06/03
Warning!Inadequate cable connections can lead to short-circuits which cause
the following:
• cable fires
• triggering of the airbag
• damage to electronic control equipment
• failure of electrical functions (blinkers, brake-lights, horn, ignition, lights).
Warning! Due to the risk of short-circuits, always disconnect the negative
terminal of the battery before starting to work on the electrical equipment of the
vehicle.
If the vehicle is equipped with a supplementary battery; also disconnect its
negative terminal.
Caution!When disconnecting the negative terminal of the battery, all volatile
memories of the comfort-electronics lose their stored data.
Depending on the vehicle's equipment, the following date may need to be reprogrammed:
Radio-code...vehicle clock
Instructions on how to reset these can be found in the relevant operating instructions.
Warning! Parts of the remote control MS-IR2 for cruise control MS-400 and
MS-700 which are fastened in the vehicle, must be fastened in such a way
that they do not detach under any circumstances (hard-braking, traffic
accident) and thus cause injuries of the passengers.
Caution! For checking the voltage in electrical lines only a diode test lamp
(see
(see
electronics may be damaged.
Caution! In order to avoid damages, pay attention that there is sufficient free
space for the drill outlet (see
treated with a rustproofing agent.
15:27 Page 22
All manuals and user guides at all-guides.com
Safety and installation instructions
timeswitch clock onboard computer seat position
A 1) or a voltmeter (see
A3) which light up consume too much current and the vehicle
A 2) may be used for checking. Test lamps
. A 4). Every drill hole must be deburred and
22