Scope Of Delivery; Holder Assembly; Control Unit Assembly; On/Off Switch Assembly - Waeco MagicSpeed Instructions De Montage Et De Service

MS-ir2 24/06/03
The following are required for the installation and assembly:
– measure (see
– prick punch (see
– screwdriver (see
The following are required for the electrical connection and the check:
– diode test lamp (see
or a voltmeter (see
– insulation tape
Quantity Designation
1 Control unit (see
1 Electronic module (see
2 Belt webbing (see
1 Holder (see
1 ON/OFF switch (see
1 Receiver (see
1 Cable harness (see
3 Adapter (see
6 Double-sided adhesive tape (see
4 Label (see
1 Plug casing (see
2 Bolts (see
(see D
(see E)
(see F
(see G
15:27 Page 23
All manuals and user guides at all-guides.com
Necessary tool
B 1)
B 2)
B 3)
A 1)
B 6)

Scope of delivery

C 1)
C 2)
C 3)
C 4)
C 5)
C 6)
C 7)
C 8)
C 10)
C 11)
C 12)

Holder assembly

Control unit assembly

ON/OFF switch assembly

Receiver assembly

– drill bits (see B 7)
– drill (see (B 8)
– solder (see A1)
– soldering iron (see
Article No.
MS-IR-TX
MS-IR-EM2
MS-IR-GB
MS-IR-HA
MS-IR-SW
MS-IR-RX
MS-IR-KA2
MS-IR-AD
C 9)
MS-IR-ST
23
B 5)