Altrad Belle HPP Manuel De L'opérateur page 19

Problem Cause
Fuel tap switched off.
Fuel shortage.
Fuel line blocked.
Air vents in lter cap blocked.
Air cleaner blocked.
Engine malfunctions.
Engine stops or will not
Low engine oil (Gasoline only).
start.
Insuf cient oil in hydraulic tank (Gasoline
only).
Engine Ignition switch or connecting wires
damaged (Gasoline units only).
Hydraulic tank oat switch wires damaged
(Gasoline units only).
Hydraulic pump seized.
Bypass lever is in the 'BYPASS' position.
Relief valve set low or worn.
Hydraulic Oil Pressure
low.
Pump worn or damaged.
Engine power low.
Radiator ns blocked.
Oil cooler fan damaged.
Hydraulic pump worn or damaged.
Accessory Tool running
hot or loose.
Relief valve set low or worn.
Hydraulic oil contaminated.
P.O.D. Cylinder seized in retracted position.
Engine speed remains
at idle when tools are
P.O.D. Cable adjustment
operated.
(20-140X & 20-160X only)
Throttle lever incorrectly set at low speed.
Engine speed remains
P.O.D. Cylinder seized in extended position. Check cylinder and replace as necessary.
at full when off load /
P.O.D. Cable adjustment incorrect.
Bypass.
All manuals and user guides at all-guides.com
Troubleshooting Guide
19
Remedy
Switch on fuel tap.
Refuel.
Clean lters/pipes.
Clean.
Clean or renew element. Refer to engine manual.
Refer to engine manual.
Top up to correct level. Refer to engine manual for
correct grade.
Top up to correct level (Refer to Technical Data Section)
Check for earth leak, and renew worn or damaged parts.
Renew worn or damaged parts.
Renew pump.
Set to 'FLOW'.
Check relief valve setting and adjust.
Check system oil ow. Renew pump as necessary.
Refer to engine manual.
Clean using air blast.
Tighten or renew as necessary
Renew pump.
Check setting and renew as necessary.
Drain oil tank and transmission hoses and replenish with
clean oil. Replace lters.
Check the cylinder and replace as necessary
Re-adjust as necessary.
Reset engine speed and lock throttle lever.
Re-adjust as necessary.