Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED3090-F-CS-L1-UNV-WRS Directives D'installation page 5

Installation Instructions – Lumiere WRx (Remote driver housing – Round Wall or Round Square)
CYLINDERS
13. Route fixture lead wires (J) from remote driver housing (H) to junction box.
14. Unscrew 2x mounting hardware (L) from junction box cover plate (M).
15. Route fixture lead wires (J) and ground wire out of center hole in junction box cover plate (M), Attach junction box cover
plate (M) to existing junction box with proper hardware (not included).
16. Connect fixture lead wires (J) from remote driver housing (H) to fixture assembly (N) following wire table. Ensure ground
wire is attached to junction box.
17 . Attach mount plate and gasket (P) to junction box cover plate with 2x mounting hardware (L). Ensure adequate gasket
compression to provide proper seal from the environment.
Figure 11. FIXTURE ASSEMBLY 9000-W1-WRS VERSION
RD BK
Mount Plate And Gasket (P)
Mounting Hardware (L)
Fixture Assembly (N)
COOPER LIGHTING SOLUTIONS
Junction Box Cover Plate (M)
Fixture Lead Wires (J) And Ground Wire
GN
IL506001EN Installation instructions
5 5