Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED3090-F-CS-L1-UNV-WRS Directives D'installation page 3

Installation Instructions – Lumiere WRx (Remote driver housing – Round Wall or Round Square)
Figure 4. 1000-A1-WRR VERSION
Figure 5. 1000-S1-WRR VERSION
Figure 6. 1000-S1-WRR VERSION
Figure 7. MOUNTING PLATE (C)
13. Route fixture lead wires (J) from remote driver housing
(H) to junction box.
14. Unscrew 4x mounting hardware (L) from junction box
cover plate (M).
15. Route fixture lead wires (J) and ground wire out of
center hole in junction box cover plate (M), Attach
junction box cover plate (M) to existing junction box
with proper hardware (not included).
16. Connect fixture lead wires (J) from remote driver
housing (H) to fixture assembly (N) following wire table.
Ensure ground wire is attached to junction box.
17 . Attach mount plate and gasket (P) to junction box cover
plate with 4x mounting hardware (L). Ensure adequate
gasket compression to provide proper seal from the
environment.
18. Using a 3/32" Allen Wrench, slightly loosen the knuckle
base set screw (R) for rotational adjustment. Using
a 9/64" Allen Wrench, slightly loosen the knuckle
joint screw (S) for angle adjustment. Once properly
positioned, ensure both screws are secured.
COOPER LIGHTING SOLUTIONS
Mounting Tracks (E)
7 .25
5.80
1.60
4.60
IL506001EN Installation instructions
Attachment
Location
Detail (D)
3