Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED3090-F-CS-L1-UNV-WRS Directives D'installation page 4

Installation Instructions – Lumiere WRx (Remote driver housing – Round Wall or Round Square)
INSTALLATION
CYLINDERS
1. Unpack and ensure all included parts are present.
2. Remove bottom end cap (with two conduit entries) and
gasket (B) by unscrewing 4x #8-32 screws (A).
3. Mounting plate (C) will slide out from tracks in extruded
driver housing (H).
4. Place mounting plate (C) on the surface to outline
attachment location holes (D). Properly secure
mounting plate on the mounting surface.
5. Attach conduit with power supply wires (K) to bottom
end cap (B).
6. Connect the Input power supply wires (K) coming out
of the driver housing (H) to power supply wires (K),
following wiring table.
7 . Remove Top end cap (with one conduit entry) and
gasket (G) by unscrewing 4x #8-32 screws (F).
8. Attach conduit and fixture lead wires (J) to top end
cap (G). Recommended to use min 18ga wires and
1000VAC min voltage rating. Max remote distance is
25ft for light level L3 and 60ft for light level L1, L2, LC1
and LC2.
9. (example catalog number: 9004-W1-RW-LED4080-S-BK-
L3-UNV-WRR).
10. Connect the DC Output wires (J) coming out of the
driver housing (H) to fixture lead wires (J), following
wiring table.
11. Push wires inside the driver housing (H). Return top
end cap and gaskets (G) to the top of driver housing
(H). Ensure proper sealing of driver housing (H).
12. Slide driver housing (H) back onto mounting tracks (E).
Push wires inside the driver housing (H). Return bottom
end cap and gasket (B) to the bottom of driver housing.
Ensure proper sealing of driver housing (H).
Ground Wire
Mount Plate
And Gasket (P)
Mounting Hardware (L)
Fixture Assembly (N)
Figure 8. FIXTURE ASSEMBLY 9000-W1-WRS VERSION
4
COOPER LIGHTING SOLUTIONS IL506001EN
Junction Box Cover Plate (M)
Installation instructions
Fixture Lead Wires (J)
Screws (F)
Top Endcap And
Gasket (G)
Driver Housing (H)
Mount Plate (C)
Bottom Endcap
And Gasket (B)
Screws (A)
Ac Power Supply
Wires (K)
Figure 9. REMOTE DRIVER ENCLOSURE
Mounting Surface
Conduit (By Others)
Screws (F)
Top End Cap And Gasket (G)
Fixture Lead Wires (J)
Mounting Plate (C)
Driver Housing (H)
Ac Power Supply Wires (K)
Bottom End Cap
And Gasket (B)
Screws (A)
Conduit (by others)
Figure 10. REMOTE DRIVER ENCLOSURE
Figure 10. FIXTURE ASSEMBLY 9000-W1-WRS VERSION
2X 3/4"
NPSM
RD GN
BK
PU
BK
WH
GR
GN