Abus TVIP52502 Manuel Utilisateur page 61

All manuals and user guides at all-guides.com
Icon explanation
A flash in the triangle is used if there is danger for the health, e.g. by an electric shock.
An exclamation mark in the triangle points to an important note in this user manual
which must be minded.
This symbol can be found when you are to be given tips and information on operation.
Important safety advice
The warranty will expire for damage due to non-compliance with these operating
instructions. ABUS will not be liable for any consequential loss!
ABUS will not accept liability for damage to property or personal injury caused by
incorrect handling or non-compliance with the safety-instructions.
In such cases the warranty will expire.
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require servicing. Dismantling the product
invalidates the CE certification and the guarantee / warranty.

The product may be damaged if it is dropped, even from a low height.

Install the device so that the image sensor is not subjected to direct sunlight. Pay attention to the
installation instructions in the corresponding section of this user guide.

This device is designed solely for use indoors or in weatherproof housing.
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapours, or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging, etc.,
can pose a danger to children if played with.

The surveillance camera contains small parts which could be swallowed, and should be kept out of
reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and user guides for the other connected devices.

Check the device for damage before commissioning. Do not put the device into operation if you
detect any damage.

Adhere to the operating voltage limits specified in the technical data. Higher voltages could
destroy the device and pose a health risk (electric shock).
61