Installation; Electrical Connection - VEDETTE VFD300SEW Manuel D'utilisation

Installation

Location
Select a location without direct exposure to sunlight;
y
Select a location with enough space for the refrigerator doors to open easily;
y
Select a location with level (or nearly level) flooring;
y
y Allow sufficient space to install the refrigerator on a flat surface;
Allow clearance to the right, left, back and top when installing. This will help
y
reduce power consumption and keep your energy bills lower.
Keep at lest 50mm gap at two sides and back.
y
The appliance should be installed well away from sources of heat such
as radiators, boilers, direct sunlight etc. Ensure that air can circulate
freely around the back of the appliance. To ensure best performance, if
the appliance is positioned below an overhanging wall unit, the minimum
distance between the top of the appliance and the wall unit must be at
least 100 mm. Ideally, however, the appliance should not be positioned
below overhanging wall units. Accurate leveling is ensured by one or more
adjustable feet at the base of the refrigerator.
This refrigerating appliance is not intended to be used as a built-in
appliance;
Warning! It must be possible to disconnect the appliance from the
mains power supply; the plug must therefore be easily accessible
after installation.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the
rating plate correspond to your domestic power supply. The appliance
must be earthed. The power supply cable plug is provided with a contact
for this purpose. If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety
precautions are not observed.
This appliance complies with the E.E.C. Directives.
8
EN