Publicité
Les langues disponibles
Les langues disponibles
Show/Hide Bookmarks
Install and connect switch unit
1. Break free opening M20 at the carrier housing or remove cover.
2. Bolt switch unit into the opening from outside.
- Enclosure IP55 is maintained thanks to the preassembled seal.
3. Fix sticker to the carrier housing.
4. Connect switch unit to the function module.
5. For function modules with terminals X3/7 and X3/39:
- Connect X3/7 and X3/39 using a jumper.
6. Parameterize controller, if necessary.
l
Switch unit - Installation
- 4 -
EDK82ZBX020 3.0
Publicité
