Start And Stop - Atlas Copco Chicago Pneumatic CP 4608 P Prescriptions De Sécurité Et Instructions Pour L'opérateur

CP 4608 P, CP 4611 P, CP 4608 D, CP 4611 D
Insertion tool
CAUTION Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp insertion tool.
►
Wait until the insertion tool has cooled down
►
before carrying out maintenance work.
NOTICE Never cool a hot insertion tool in water,
it can result in brittleness and early failure.
Selecting the right insertion tool
Selecting the right insertion tool is a precondition
for proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.
Narrow chisel
Moil point
WARNING Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
►
well-maintained, not worn out and of the proper
size.
Always use a sharp tool in order to work
►
efficiently.
9800 0551 90e | Original instructions
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
Safety and operating instructions
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
To prevent an accidental start: switch off the air
♦
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
♦ Before inserting a tool, lubricate the tool shank
with grease.
Close the tool retainer and check the lock function
♦
by tugging the inserted tool sharply outwards.
CP 4608 and CP 4611
B
1. Assemble the parts as shown (A).
2. Insert the lock coil (B) into the tool retainer.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
► Stop the machine immediately in all cases of
power supply interruption.

Start and stop

NOTICE Do not start the machine without an
inserted tool fitted. Starting the machine without an
inserted tool will cause damage to the impact
mechanism.
CP 4608 P, CP 4611 P
A
15